|
Image plane Thickness
|
|
06-11-2016, 01:05 PM
(This post was last modified: 04-14-2018 08:36 AM by Ramjet.)
Post: #14
|
|||
|
|||
|
RE: Image plane Thickness
Hum, with Wings 3D 1.5.4,
I don't know if its a bug, but with Move->Normal at the second Weld I lost the verso image, and at the third Weld I lost the recto. So, after I must remap the UV! It is exactly the same behavior if I try to Weld directly the Image Plane object without any move. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Image plane Thickness - Ramjet - 07-31-2015, 06:57 AM
RE: Image plane Thickness - micheus - 07-31-2015, 07:48 AM
RE: Image plane Thickness - Ramjet - 07-31-2015, 10:27 AM
RE: Image plane Thickness - Ramjet - 06-02-2016, 12:38 PM
RE: Image plane Thickness - micheus - 06-02-2016, 03:53 PM
RE: Image plane Thickness - Ramjet - 06-04-2016, 12:34 PM
RE: Image plane Thickness - micheus - 06-04-2016, 01:18 PM
RE: Image plane Thickness - Fonte Boa - 06-04-2016, 06:19 PM
RE: Image plane Thickness - micheus - 06-04-2016, 08:11 PM
RE: Image plane Thickness - Ramjet - 06-05-2016, 07:48 AM
RE: Image plane Thickness - micheus - 06-05-2016, 08:28 AM
RE: Image plane Thickness - Ramjet - 06-11-2016, 12:08 PM
RE: Image plane Thickness - micheus - 06-11-2016, 12:32 PM
RE: Image plane Thickness - Ramjet - 06-11-2016 01:05 PM
RE: Image plane Thickness - micheus - 06-11-2016, 01:16 PM
RE: Image plane Thickness - Ramjet - 06-11-2016, 02:00 PM
|
User(s) browsing this thread: 1 Guest(s)