|
Unify edge length
|
|
09-19-2015, 06:03 PM
Post: #6
|
||||
|
||||
|
RE: Unify edge length
Yeah! I also missed this resource.
What I would offer to you as an alternative is to work with selections (from the entire faces - less one) and rotate around a picked axis. But, it will not produce the correct result anyway - except for a coincidence.  Then, you could start from a cylinder to get this:  if that area will have any kind of fastening, maybe it could not be a problem.
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Unify edge length - esha - 09-19-2015, 01:18 PM
RE: Unify edge length - ggaliens - 09-19-2015, 02:02 PM
RE: Unify edge length - esha - 09-19-2015, 02:19 PM
RE: Unify edge length - ggaliens - 09-19-2015, 03:24 PM
RE: Unify edge length - esha - 09-19-2015, 04:28 PM
RE: Unify edge length - micheus - 09-19-2015 06:03 PM
RE: Unify edge length - micheus - 09-20-2015, 04:59 AM
RE: Unify edge length - ggaliens - 09-22-2015, 02:36 AM
RE: Unify edge length - micheus - 09-22-2015, 11:46 AM
RE: Unify edge length - beng27 - 03-31-2016, 04:05 PM
RE: Unify edge length - ggaliens - 03-31-2016, 05:18 PM
RE: Unify edge length - micheus - 03-31-2016, 05:53 PM
RE: Unify edge length - beng27 - 04-02-2016, 10:31 AM
RE: Unify edge length - ggaliens - 04-02-2016, 03:25 PM
RE: Unify edge length - beng27 - 04-22-2016, 05:41 PM
RE: Unify edge length - ggaliens - 04-22-2016, 07:54 PM
|
User(s) browsing this thread: 1 Guest(s)