|
Unify edge length
|
|
04-02-2016, 10:31 AM
Post: #13
|
|||
|
|||
|
RE: Unify edge length
OK, that's fine, I understand.
Basically, I've recently discovered W3D and I'm using it to make 3D sculptures & then print them out. Its been a steep learning curve though Ive got fairly good at it. There are however 3 things I find myself wanting to do time and time again & unable to achieve in W3D2.02 (And TopMod seems to crash too often to be useable) The key thing for me that would really help is the ability to set a group of selected different-length edges to a particular length , and I can't find a work-around. Any way to solve this would be great, even if I have to borrow a PC to do it. So, is it included in the current ML release? Or was that a 'special' version you just knocked up to answer the OPs question? |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Unify edge length - esha - 09-19-2015, 01:18 PM
RE: Unify edge length - ggaliens - 09-19-2015, 02:02 PM
RE: Unify edge length - esha - 09-19-2015, 02:19 PM
RE: Unify edge length - ggaliens - 09-19-2015, 03:24 PM
RE: Unify edge length - esha - 09-19-2015, 04:28 PM
RE: Unify edge length - micheus - 09-19-2015, 06:03 PM
RE: Unify edge length - micheus - 09-20-2015, 04:59 AM
RE: Unify edge length - ggaliens - 09-22-2015, 02:36 AM
RE: Unify edge length - micheus - 09-22-2015, 11:46 AM
RE: Unify edge length - beng27 - 03-31-2016, 04:05 PM
RE: Unify edge length - ggaliens - 03-31-2016, 05:18 PM
RE: Unify edge length - micheus - 03-31-2016, 05:53 PM
RE: Unify edge length - beng27 - 04-02-2016 10:31 AM
RE: Unify edge length - ggaliens - 04-02-2016, 03:25 PM
RE: Unify edge length - beng27 - 04-22-2016, 05:41 PM
RE: Unify edge length - ggaliens - 04-22-2016, 07:54 PM
|
User(s) browsing this thread: 1 Guest(s)