|
Sweep between 2 faces
|
|
01-22-2016, 01:42 PM
Post: #2
|
||||
|
||||
RE: Sweep between 2 faces
(01-22-2016 11:44 AM)cyseal Wrote: It is possible to sweep between 2 faces without calculating the angle and extruding?No. By considering the image, I would to say that you could to use a portion of 270 degree of a Cylinder (Tube); or extrude one face of the "cross", segment it and use blend to curve it; or you could Bridge the two faces of the "cross", select the new edges, cut them by n segments, select again the new edges and use Circularize by +/-270°.
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Sweep between 2 faces - cyseal - 01-22-2016, 11:44 AM
RE: Sweep between 2 faces - micheus - 01-22-2016 01:42 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 02:11 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 02:27 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 02:46 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 02:55 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 03:43 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 03:52 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 04:55 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 05:09 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 05:19 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 05:52 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 06:11 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 06:29 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 06:30 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 06:35 PM
|
User(s) browsing this thread: 1 Guest(s)