|
Sweep between 2 faces
|
|
01-22-2016, 02:27 PM
(This post was last modified: 01-22-2016 02:33 PM by Fonte Boa.)
Post: #4
|
|||
|
|||
|
RE: Sweep between 2 faces
I was recording a video while Micheus was typing!
You can reach the results you want by using RMB Bend (click on Bend command using right mouse button to reach TopRad Bend coomand)(keep an eye on infoline). The results are about 100% exact: you should select the final faces, Bridge them and, finally, use CleanUp to eliminate coincident vertices. Please, let me know if the video was userful for you. Remember: RMB Bend is a three-step operation (point rod center, point rod top, point bend normal) https://youtu.be/qtorzQwr3t8 __________________________________ http://www.youtube.com/wings3dchannel http://www.facebook.com/wings3dchannel |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Sweep between 2 faces - cyseal - 01-22-2016, 11:44 AM
RE: Sweep between 2 faces - micheus - 01-22-2016, 01:42 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 02:11 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016 02:27 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 02:46 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 02:55 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 03:43 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 03:52 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 04:55 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 05:09 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 05:19 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 05:52 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 06:11 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 06:29 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 06:30 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 06:35 PM
|
User(s) browsing this thread: 1 Guest(s)