|
Sweep between 2 faces
|
|
01-22-2016, 04:55 PM
(This post was last modified: 01-22-2016 05:05 PM by cyseal.)
Post: #9
|
|||
|
|||
|
RE: Sweep between 2 faces
Thanks, nice flow.
After you cut and connect, what two edges did you select ? I can't get the correct loop ring to circularize. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Sweep between 2 faces - cyseal - 01-22-2016, 11:44 AM
RE: Sweep between 2 faces - micheus - 01-22-2016, 01:42 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 02:11 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 02:27 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 02:46 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 02:55 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 03:43 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 03:52 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016 04:55 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 05:09 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 05:19 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 05:52 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 06:11 PM
RE: Sweep between 2 faces - cyseal - 01-22-2016, 06:29 PM
RE: Sweep between 2 faces - Fonte Boa - 01-22-2016, 06:30 PM
RE: Sweep between 2 faces - micheus - 01-22-2016, 06:35 PM
|
User(s) browsing this thread: 1 Guest(s)