Wings 3D Development Forum
/
Wings 3D
/
ManifoldLab Plug-ins Collection 
/
Request for automatic handle
/
Request for automatic handle
|
Request for automatic handle
|
|
02-05-2016, 10:50 AM
(This post was last modified: 02-05-2016 11:49 AM by cyseal.)
Post: #10
|
|||
|
|||
|
RE: Request for automatic handle
ggaliens,
I'll remake them and I'll send them to you. I think I used two "crust" algorithms in TopMod. It basically splits one handle in two handles but also changes the overall geometry (adds some volume to it). I'll make them without it as soon as I come home from work. Can I post it here so that anybody could join discussion about handlebody ? ___________________________________________________________________________________________ So the idea would be to have some templates that would go from plain old arc to say maybe exercise "kettle-bell" handle or an iron handle and pick the one that is more appropriate for the situation. Cyseal ... I noticed that your TOP mode did export some handles that were not ARCS. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Request for automatic handle - cyseal - 02-01-2016, 08:57 PM
RE: Request for automatic handle - ggaliens - 02-03-2016, 03:47 PM
RE: Request for automatic handle - ggaliens - 02-04-2016, 04:33 AM
RE: Request for automatic handle - ggaliens - 02-04-2016, 06:13 AM
RE: Request for automatic handle - ggaliens - 02-04-2016, 02:49 PM
RE: Request for automatic handle - cyseal - 02-04-2016, 04:01 PM
RE: Request for automatic handle - ggaliens - 02-04-2016, 04:34 PM
RE: Request for automatic handle - micheus - 02-04-2016, 04:37 PM
RE: Request for automatic handle - ggaliens - 02-04-2016, 05:20 PM
RE: Request for automatic handle - cyseal - 02-05-2016 10:50 AM
RE: Request for automatic handle - cyseal - 02-05-2016, 07:33 PM
|
User(s) browsing this thread: 1 Guest(s)