|
Overhand Knot
|
|
02-16-2016, 06:13 PM
(This post was last modified: 02-16-2016 06:19 PM by ggaliens.)
Post: #6
|
|||
|
|||
|
RE: How To: Overhand Knot
Seems like you picked a bad place to cut your knot before extrude. I would offer that maybe a careful magnet move via the extruded edges might recenter then to avoid unwanted overlaps. Don't have time to share more than words today.
|
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Overhand Knot - micheus - 02-16-2016, 04:33 AM
RE: How To: Overhand Knot - ggaliens - 02-16-2016, 05:08 PM
RE: How To: Overhand Knot - micheus - 02-16-2016, 05:10 PM
RE: How To: Overhand Knot - ggaliens - 02-16-2016, 05:12 PM
RE: How To: Overhand Knot - micheus - 02-16-2016, 05:57 PM
RE: How To: Overhand Knot - ggaliens - 02-16-2016 06:13 PM
RE: How To: Overhand Knot - micheus - 02-16-2016, 06:21 PM
RE: How To: Overhand Knot - ggaliens - 02-16-2016, 06:32 PM
RE: How To: Overhand Knot - cyseal - 02-16-2016, 09:54 PM
|
User(s) browsing this thread: 1 Guest(s)