Wings 3D Development Forum / Wings 3D / Programming v / Checking for parallel vectors - something is wrong.

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
Checking for parallel vectors - something is wrong.
03-27-2016, 02:51 AM
Post: #6
ggaliens Offline
Erlang Hacker
 		Posts: 954
Joined: Nov 2012
RE: Checking for parallel vectors - something is wrong.
""By the Dot Product definition, I was expecting to get a value other than zero. It should happens only if both vectors were parallel to each other. (Am I wrong?)"


Yes ... you were wrong.
Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
RE: Checking for parallel vectors - something is wrong. - ggaliens - 03-27-2016 02:51 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication