How to use mirror?

[cyseal]

How to use mirror so that you model only one side of the mesh and then just mirror it on other?
For example, in modeling this dragon I would like to model only one side and then mirror it to other.

[ggaliens]

Personal opinion ... don't use virtual mirror. Just use loop-cut and mirror only as often as you really need it.

[cyseal]

(04-04-2016 11:52 AM)ggaliens Wrote:  Personal opinion ... don't use virtual mirror. Just use loop-cut and mirror only as often as you really need it.

I don't understand.

[micheus]

(04-04-2016 09:40 AM)cyseal Wrote:  How to use mirror so that you model only one side of the mesh and then just mirror it on other?

Usually you do it this way: https://youtu.be/Bl4ngBPIRVI?t=1m55s

[ggaliens]

I would to what Micheus did ... except I would pick face/mirror rather than virtual mirror.

I don't like the constant updates while I'm working. I only need it every so often.

[cyseal]

Thanks.

[Mishou]

I use virtual mirror while modelling in order to be able to get the best view angle, however, in the end i remove the virtual one and i pick a face and mirror it in the end.