Wings 3D Development Forum / Wings 3D / Design & Development v / YafaRay Plug-in - reviewing for Yafaray 3.0

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
YafaRay Plug-in - reviewing for Yafaray 3.0
10-07-2016, 11:21 PM (This post was last modified: 10-07-2016 11:30 PM by oort.)
Post: #139
oort Offline
3D Obsessed
 		Posts: 1,158
Joined: Nov 2012
RE: YafaRay Plug-in - reviewing for Yafaray 3.0
I found a couple of webpages with information about using a single image with Alpha for leaves.

Blender3D: Noob to Pro Wiki

Blender Doc

Based on this, I think it is the DVar setting that is missing and causing the problem. If I understand correctly the DVar setting controls the "Scalar" setting.

Quote:Dvar: default value for scalar type textures (Mirror Amount, Transparency, etc..)
from this page... YafaRay Textures

There are two settings for that:
"do_scalar" (bool, default is true) and "scalar" (float, default is 1.0).

YafaRay XML parameters

Problem now is figuring out where to put the code... so far I have not been able to get it right... Sad
Hopefully adding this will fix the problem... Smile

oort
Website Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
RE: YafaRay Plug-in - reviewing for Yafaray 3.0 - oort - 10-07-2016 11:21 PM
RE: YafaRay Rendering Software - oort - 07-15-2016, 02:28 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication