[Fixed] Tools | Magnet Mask | Select/Deselect not working

[tkbd]

Fonte Boa,What was the selection modes used in your workflow?

I tried reproduce that close condition by edge loop selection.
There are cases where it is not displayed depending on the selection mode.

-Make Sphere and smooth x 2
-(Edge Selection Mode)Select a couple of edge Loop, mask them.
-Deselect all edges
-Switch Face Selection Mode
-Deselect (Press a space key)
-(Then,switch to Multi Selection mode... ex. Vertex/Edge/Face)
-Tools | Magnet Mask | Select
-But selection area isn't appear.

But your case are used edge ring aren't you?
it is mysterious....