A trouble in modelling snowman

[Drayldan]

Hi Marcin,

Kudos to your modeling abilities and W3D knowledge!

Thanks for your tips, it works in general!
I think I made a mistake when dividing cylinder mesh... Somehow it wasn't cut on all faces I selected. Could you pass a tip to fast and properly divide one face onto two ones? Because I would like to extrude only half of the cylinder, of course.

Then next question is: how to use "cleanup" ? I cannot find that command in W3D.


P.S.
In contrary to appearances, I am also from the country on the Vistula River.