The Peacebreaker

New Reply

Thread Rating:

1 Vote(s) - 4 Average
1
2
3
4
5

Share Thread:

Threaded Mode | Linear Mode

The Peacebreaker

07-27-2017, 05:05 PM

Post: #5

micheus Offline

Forum's Admin and Support

Posts: 3,354
Joined: Jun 2012

RE: The Peacebreaker (Work in progress)

(07-27-2017 03:03 PM)Priceless Wrote: Is there Any other way to do it?

You could just added the edges as I shown and after that used the Flatten to ensure the faces around the hole would be coplanar. Just a little faster. Wink

* Wings3D Team stands for: Björn and Dan

Find

« Next Oldest | Next Newest »

New Reply

Messages In This Thread

The Peacebreaker - Priceless - 07-27-2017, 08:26 AM

RE: The Peacebreaker (Work in progress) - micheus - 07-27-2017, 01:29 PM

RE: The Peacebreaker (Work in progress) - Priceless - 07-27-2017, 01:56 PM

RE: The Peacebreaker (Work in progress) - Priceless - 07-27-2017, 03:03 PM

RE: The Peacebreaker (Work in progress) - micheus - 07-27-2017 05:05 PM

RE: The Peacebreaker (Work in progress) - Priceless - 07-27-2017, 05:15 PM

RE: The Peacebreaker (Work in progress) - Priceless - 08-04-2017, 04:01 PM

RE: The Peacebreaker (Work in progress) - micheus - 08-04-2017, 04:28 PM

RE: The Peacebreaker (Work in progress) - Priceless - 08-04-2017, 04:36 PM

RE: The Peacebreaker (Work in progress) - olve11 - 08-08-2017, 06:22 PM

RE: The Peacebreaker (Work in progress) - Priceless - 08-09-2017, 07:30 AM

RE: The Peacebreaker (Work in progress) - Priceless - 08-09-2017, 10:54 AM

RE: The Peacebreaker (Work in progress) - Priceless - 11-10-2017, 08:56 AM

RE: The Peacebreaker (COMPLETED) - micheus - 11-10-2017, 04:19 PM

RE: The Peacebreaker (COMPLETED) - Priceless - 11-11-2017, 02:38 AM

User(s) browsing this thread: 1 Guest(s)