Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Bridge won't apply to the 2 faces
10-04-2017, 02:45 AM
Post: #1
Bridge won't apply to the 2 faces
Hi, I was trying to follow Step 23 of this tutorial:

http://www.wings3d.com/paulthepuzzles/aaBT1s.html

I was following along exactly but it won't apply the bridge. Advice?


Attached File(s) Thumbnail(s)
   
Reply
10-04-2017, 03:04 AM (This post was last modified: 10-04-2017 05:01 AM by micheus.)
Post: #2
RE: Bridge won't apply to the 2 faces
The message seems to be coherent with the image you attached.
I am seeing all the Faces turned to the camera view.
So, to be able to bridge then you need to select faces that are pointing to each other - at least almost. You also can apply this command to each pair of faces - you cannot select the four faces as it seems to be in your image.

Did this help you to find what is wrong?
I'm away from my PC, so I can't illustrate it now.

My Wings3D Collection at G+
Reply
10-04-2017, 05:16 AM (This post was last modified: 10-04-2017 05:16 AM by micheus.)
Post: #3
RE: Bridge won't apply to the 2 faces
Let's try this way...

Looking from the bottom the faces you should make one are these shown bellow:


Now, to help you to understand where is the selection compared to your image notice the coloured table legs only the inner faces for bridge are selected:


In your image both selections are facing the camera view. Wink

My Wings3D Collection at G+
Reply


Forum Jump:


User(s) browsing this thread: 1 Guest(s)