|
Bridge won't apply to the 2 faces
|
|
10-03-2017, 04:45 PM
Post: #1
|
|||
|
|||
|
Bridge won't apply to the 2 faces
Hi, I was trying to follow Step 23 of this tutorial:
http://www.wings3d.com/paulthepuzzles/aaBT1s.html I was following along exactly but it won't apply the bridge. Advice? |
|||
|
10-03-2017, 05:04 PM
(This post was last modified: 10-03-2017 07:01 PM by micheus.)
Post: #2
|
||||
|
||||
|
RE: Bridge won't apply to the 2 faces
The message seems to be coherent with the image you attached.
I am seeing all the Faces turned to the camera view. So, to be able to bridge then you need to select faces that are pointing to each other - at least almost. You also can apply this command to each pair of faces - you cannot select the four faces as it seems to be in your image. Did this help you to find what is wrong? I'm away from my PC, so I can't illustrate it now.
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
10-03-2017, 07:16 PM
(This post was last modified: 10-03-2017 07:16 PM by micheus.)
Post: #3
|
||||
|
||||
|
RE: Bridge won't apply to the 2 faces
Let's try this way...
Looking from the bottom the faces you should make one are these shown bellow:  Now, to help you to understand where is the selection compared to your image notice the coloured table legs only the inner faces for bridge are selected:  In your image both selections are facing the camera view. 
|
||||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)