|
[not a bug] Loop cut tube bug
|
|
11-10-2018, 02:41 AM
(This post was last modified: 12-12-2018 02:17 AM by micheus.)
Post: #1
|
|||
|
|||
|
[not a bug] Loop cut tube bug
Create a tube
right click -> Cylinder -> Gear icon click "tube" -> OK Now two ways to see this bug. 1. Select all the up-facing faces Extrude Y up Loop select inside and outside middle seams Loop cut There is an undeletable face inside both ends of the halves. 2. Select the top faces Extract up There is an undeletable face in the center. I'd rather live with false hope than with false despair. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
[not a bug] Loop cut tube bug - some_yahoo - 11-10-2018 02:41 AM
RE: Loop cut tube bug - micheus - 11-10-2018, 09:03 AM
RE: Loop cut tube bug - some_yahoo - 11-11-2018, 12:24 AM
RE: Loop cut tube bug - Hank - 11-11-2018, 08:11 AM
RE: Loop cut tube bug - micheus - 11-12-2018, 12:04 AM
|
User(s) browsing this thread: 1 Guest(s)