|
Holes in Wings3D?
|
|
05-09-2020, 07:30 PM
Post: #1
|
|||
|
|||
|
Holes in Wings3D?
So I need to make a hole in the model I am designing. I put a photo below. Need to cut the red part. Is there any way of doing this on Wings3d?
|
|||
|
05-10-2020, 01:57 AM
Post: #2
|
||||
|
||||
|
RE: Holes in Wings3D?
It's kind of a obvious question, but did you tried the Hole command?
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
05-10-2020, 08:11 AM
Post: #3
|
|||
|
|||
|
RE: Holes in Wings3D?
Okay, sorry about that. Didnt even know that was a command. Thanks so much!
|
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)