looking for someone to finalize a design

[engrenage]

Hello!

I have been (physically) working on my "egg" (it's basically done, I still need to make a video to show the result and steps) and at the same time I've been working on a box (as in the french "boîtier") for a young company /startup designing and selling grow lights as well as assorted hardware such as environmental sensors.

We have our first PCB prototype available - the current shortage of semiconductors is a pain in the butt - and I've designed the box that should fit around it.

Only... I've only designed the outside of the shell. I suffer from some form of arthritis and using a mouse causes me severe pain. I'm looking for someone who knows Wings fairly well and would be willing - in exchange for remuneration - to just finish it off so it's printable in two parts (top and bottom, with some 6 screws or so) that don't interfere with the PCB and components (stl available) and have some kind of bevel so they fit together nicely. It is also desired to add a few cooling vents.

Is anyone out here available for this task? If yes, at what cost?

[RubberMan]

Would love to say yes but I can't for the life of me figure out wtf it is by looking at the picture
I can just make out what I think are LEDs? and what could be IC slots.


P.S. Recently made some stackable microgreen trays lol

[engrenage]

it's a 0-12 VDC dimmer for grow lights.

apparently my colleague found someone already ; I'll get back here if his works proves to be unsatisfying

[engrenage]

well it turns out the other guy is totally unsatisfying.