collada export - wrong normals

[micheus]

oort, I checked and Wings3d is exporting the right face normals.

Specifically about the viewer, I noticed that if I just export the simple mesh its logs points a error:

Quote:...
Debug, T11292: START `postprocess`
Debug, T11292: FindInvalidDataProcess begin
Error, T11292: FindInvalidDataProcess fails on mesh uvcoords: All vectors are identical
Info, T11292: FindInvalidDataProcess finished. Found issues ...
...

after that, I UV mapped my mesh and the normals was shown right:
left: without UVs; right: after add the UV mapping;

So, maybe other importers need this too.
Neon22, can you check this?