crash with snapshot & 1.5.1 when smoothing

[Stem]

(11-04-2013 09:47 AM)dgud Wrote:  Even with the newest snapshot?

I am using the version you posted the link to on this thread.

It is repeatable using the steps I mentioned above.
It does appear more stable apart from that, as before it was crashing during inflate. [ <- I spoke too soon. Just crashed while using inflate. The crash is now always due to faulting module nvoglv64.dll I will look at some other drivers.]

As there is no dump created, I can only give you the info I see from windows error (pic attached).

I take it this is a problem just with nVidia? I do have an AMD 7850, so I can put that in and check if needed?

Just to add:-
If I sub_d slowly, [leave a few seconds between each sub-d], then as I mentioned, not a problem. I have just sub-d a cube 11 times, giving 6,291,456 polygons (using 9.4 GB of memory). Not that I would actually do that normally LOL.(as it does get unresponsive)