|
How to make a trumpet bell
|
|
11-09-2013, 10:57 PM
Post: #5
|
|||
|
|||
RE: How to make a trumpet bell
(11-09-2013 10:35 PM)gungazoid Wrote: when I do that, nothing happens for "G" or "g". When I select one of the edges on the side of the cylinder, it selects to two edges of that polygon that touch the top and bottom rings...you can do that by selection of the top face and then switch to edge mode. I suggest you to watch some videos from the tutorials thread. You need a basic knoledgement about the interface and basics commands before we can explain things for you that you can understand. 
|
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
RE: My 3D/2D gallery - gungazoid - 11-09-2013, 03:59 PM
RE: How to make a trumpet bell - Justanother1 - 11-09-2013, 10:14 PM
RE: How to make a trumpet bell - gungazoid - 11-09-2013, 10:35 PM
RE: How to make a trumpet bell - micheus - 11-09-2013 10:57 PM
RE: How to make a trumpet bell - Justanother1 - 11-10-2013, 07:19 PM
RE: How to make a trumpet bell - puzzledpaul - 11-10-2013, 08:16 PM
RE: How to make a trumpet bell - puzzledpaul - 11-10-2013, 01:18 PM
RE: How to make a trumpet bell - gungazoid - 11-16-2013, 06:48 PM
RE: How to make a trumpet bell - Fonte Boa - 11-21-2013, 12:46 AM
RE: How to make a trumpet bell - micheus - 11-24-2013, 07:59 AM
RE: How to make a trumpet bell - Fonte Boa - 11-26-2013, 07:29 PM
RE: My 3D/2D gallery - micheus - 11-09-2013, 04:55 PM
|
User(s) browsing this thread: 1 Guest(s)