fit big to smaller to ggaliens

[denisc]

hi all

i try this fonction with dodec-fract.wings

i am reconstruct dodecahedron_l-system_II of jotero.

S.jpg

before that , i had try why my personnel model contruct with 3Dwing ,

but the

same fonction don't work????

ex1

a simple exemple

i create dodecaedron , i select 1face and inset to 0.

i select the opposite face inside and inset to 70 percent.

i select all and duplicate and move.

first model select a little face inside

second, a big face outside

fit big to smaller

and nothing for result

ex2

if i made the inset to 70 outside the first model ,that work!!

what is a special manip?

thanks in advance

thanks in advance ggaliens

[ggaliens]

These attachments don't work so good for me.

Please post direct link and I can look at it.

[denisc]

hello

https://www.dropbox.com/s/xao8v3wsqc1jsyd/Desktop.zip

i used Wings 3D 1.5.1 for that

[ggaliens]

Sorry so darn slow. I think the answer to this one is easy ... "Fit Big to small" is very old. You must upgrade to get proper support.

[denisc]

(12-31-2013 02:28 PM)ggaliens Wrote:  Sorry so darn slow. I think the answer to this one is easy ... "Fit Big to small" is very old. You must upgrade to get proper support.

hello ggaliens

i just read post for version 1.52

My version 1.51 was builted with un old experimental tar

i retry with the new version 1.52 now.


Fit Big to small is now fit on.


cheers

denisc

[ggaliens]

I might need to re-build my .tar (beam files only ... plugins only) version.
It is probably fairly old. I thought it was from this fall ... but no date embedded in
filename. So that's an issue.

You could try the latest "all in one" versions if you were brave.