Wings 3D Development Forum
/
Wings 3D
/
ManifoldLab Plug-ins Collection 
/
fit big to smaller to ggaliens
/
fit big to smaller to ggaliens
|
fit big to smaller to ggaliens
|
|
01-06-2014, 08:48 AM
(This post was last modified: 01-06-2014 09:47 AM by denisc.)
Post: #5
|
|||
|
|||
RE: fit big to smaller to ggaliens
(12-31-2013 02:28 PM)ggaliens Wrote: Sorry so darn slow. I think the answer to this one is easy ... "Fit Big to small" is very old. You must upgrade to get proper support. hello ggaliens i just read post for version 1.52 My version 1.51 was builted with un old experimental tar i retry with the new version 1.52 now. Fit Big to small is now fit on. cheers denisc |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
fit big to smaller to ggaliens - denisc - 12-19-2013, 11:56 PM
RE: fit big to smaller to ggaliens - ggaliens - 12-20-2013, 07:31 PM
RE: fit big to smaller to ggaliens - denisc - 12-21-2013, 01:18 PM
RE: fit big to smaller to ggaliens - ggaliens - 12-31-2013, 02:28 PM
RE: fit big to smaller to ggaliens - denisc - 01-06-2014 08:48 AM
RE: fit big to smaller to ggaliens - ggaliens - 01-06-2014, 01:40 PM
|
User(s) browsing this thread: 1 Guest(s)