|
Slide vs (Dup loop and slide) ...
|
|
12-27-2013, 11:16 PM
Post: #7
|
|||
|
|||
RE: Slide vs (Dup loop and slide) ...
(12-27-2013 08:01 PM)VladD Wrote: in Wings3D to get this "loop offset" (as maya calls this very function, as suggested in the first post), is to do an edge extrusion and just changing the % value of the added parallel edges without adjusting the D(istance) of courseI think you can use Crease for this task without "bump" the original "partial edge loop". |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Slide vs (Dup loop and slide) ... - ggaliens - 12-27-2013, 02:23 PM
RE: Slide vs (Dup loop and slide) ... - Fonte Boa - 12-27-2013, 04:49 PM
RE: Slide vs (Dup loop and slide) ... - ggaliens - 12-27-2013, 05:36 PM
RE: Slide vs (Dup loop and slide) ... - micheus - 12-27-2013, 06:18 PM
RE: Slide vs (Dup loop and slide) ... - ggaliens - 12-27-2013, 07:09 PM
RE: Slide vs (Dup loop and slide) ... - VladD - 12-27-2013, 08:01 PM
RE: Slide vs (Dup loop and slide) ... - micheus - 12-27-2013 11:16 PM
RE: Slide vs (Dup loop and slide) ... - Arg Arg - 12-29-2013, 02:24 PM
RE: Slide vs (Dup loop and slide) ... - Justanother1 - 12-30-2013, 03:54 AM
RE: Slide vs (Dup loop and slide) ... - puzzledpaul - 12-30-2013, 04:09 PM
RE: Slide vs (Dup loop and slide) ... - Arg Arg - 12-30-2013, 07:04 PM
RE: Slide vs (Dup loop and slide) ... - VladD - 12-30-2013, 07:06 PM
RE: Slide vs (Dup loop and slide) ... - Dimitri - 01-02-2014, 11:44 AM
|
User(s) browsing this thread: 1 Guest(s)