Concave text

[micheus]

(04-22-2016 06:02 AM)Stimorol Wrote:  Thank you for positive answer. I need to write this concave text with depth of 0.3 mm and this depth should have angle from up to down 10-15 percent. Also when this text is ready I should write it on the end of tube. Tubes outside diameter 8mm, inside diameter 5.5 mm, that means the thichness of tube is 2.5 mm. It goes without saying that text should be curved like tubes form and should fit on the end of tube. Thank you in advance.

Stimorol, the idea is always the same.

Just notice Wings3d doesn't works with mm, cm, m, ... It uses its own unit system (WU). So, you can build your model using it as the metric system you want and export and import in the other app and scale the mode to fit in the proper metric system.

For 3d printing, someone has tested and each 1WU = 1mm. In this case you still can work using the 1WU as 1cm, but you will need to scale it ten times (1000%) before export to STL file and print your 3d model.

That said, here is another video using some references you wrote above: