|
Autosmooth and UVmapping
|
|
04-19-2014, 12:10 PM
Post: #2
|
|||
|
|||
|
RE: Autosmooth and UVmapping
About auto-smooth question.
Auto-smooth command doest subdivide the model. It just create hard edges (the yellow ones) according the angle you specify. This command apply hard edges globally to a model. You can perform this by selecting some edges and callin Edge|Hardness|Hard. Create a cube, duplicate it, select one of them, apply auto-smooth and press SHIFT+TAB (quick smooth preview): you will see the difference between them. Note this attribut (hard edges) isnt exported to another softwares, ok?! https://www.youtube.com/watch?v=bNvli3x4JwA https://www.youtube.com/watch?v=VbzL95LNrWk __________________________________ http://www.youtube.com/wings3dchannel http://www.facebook.com/wings3dchannel |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Autosmooth and UVmapping - Mary - 04-18-2014, 06:32 PM
RE: Autosmooth and UVmapping - Fonte Boa - 04-19-2014 12:10 PM
RE: Autosmooth and UVmapping - Mary - 04-19-2014, 07:05 PM
RE: Autosmooth and UVmapping - Fonte Boa - 04-19-2014, 11:01 PM
RE: Autosmooth and UVmapping - Stem - 04-20-2014, 01:01 PM
RE: Autosmooth and UVmapping - Justanother1 - 04-20-2014, 06:36 PM
RE: Autosmooth and UVmapping - Mary - 04-30-2014, 04:03 PM
RE: Autosmooth and UVmapping - Ravyn - 05-02-2014, 03:49 PM
|
User(s) browsing this thread: 1 Guest(s)