|
Cut a half-hole in a cylinder
|
|
05-15-2014, 06:17 AM
Post: #1
|
|||
|
|||
|
Cut a half-hole in a cylinder
Hi all!
I am new to wings3d. I have been to do a half-hole on the side of a cylinder but I cannot get it right. Please see attached image, I want to "drill" a hole with one of the cylinders into the other one. Any suggestions? Thanks! |
|||
|
05-15-2014, 08:24 PM
Post: #2
|
|||
|
|||
|
RE: Cut a half-hole in a cylinder
Easiest way would require the Manofoldlab version of the Program .. (google it) .. with the extra plugins. Boolean is what your looking for in Object Mode - Lots more ...... different versions have different options and clicks so read the helper instructions .....
|
|||
|
05-15-2014, 09:39 PM
Post: #3
|
|||
|
|||
RE: Cut a half-hole in a cylinder
(05-15-2014 08:24 PM)Justanother1 Wrote: Easiest way would require the Manofoldlab version of the Program .. (google it) .. with the extra plugins. Boolean is what your looking for in Object Mode - Lots more ...... different versions have different options and clicks so read the helper instructions ..... Nice! Just what I was looking for. Cheers |
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)