Beginner. Voronoi Cube.

[olishea]

Thanks.

"1) You have to do the adaptive isotropic remesh of surface"

Erm....how do I do this? haha

4) take SPIKEY output from (3) and use CarveCSG to trim the spikes to original mesh.

Where can I find Carve?

Sorry I thought this would be quite simple! I'm making "celled" or voronoi shapes for 3D printing and found I'm getting really close in wings, but it's not what I want yet. I had some good results in meshlab but I really enjoy using wings. The idea is to make some "chicken wire" sculptures/products.

I nearly got a voronoi torus, but same problem again, the lines aren't intersected into the original torus and there is internal geometry.

Thanks for the reply, I just don't understand what you mean! I'm a complete newbie at wings! I hope you are patient lol