|
Shape Extruder?
|
|
12-19-2012, 03:30 PM
Post: #13
|
|||
|
|||
|
RE: Shape Extruder?
ggaliens,
I installed your build last night. I noticed during installation there was a dialog that said my Microsoft Visual C++ 2008 X86 was not up to date. Shouldn't you be using 2010 instead? At least I think that is what is used in the official release. I aborted updating that when it told me that I first needed to close Outlook. It is nice to see previews of the models before saying ok. I had to use Manual mode because my computer is old (Pentium 4 2.4GHz). I still think it would be better if it were possible to have simple dialogs i.e. Height: 2, Diameter: 4, Length: 8. As it is, I blindly change numbers in the formulas to see what happens...   oort |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Shape Extruder? - optigon - 12-04-2012, 03:00 AM
Yes ... it is still around. - ggaliens - 12-04-2012, 04:02 AM
RE: Shape Extruder? - optigon - 12-04-2012, 05:33 AM
I think that would be nery nice feature. - ggaliens - 12-04-2012, 01:59 PM
RE: Shape Extruder? - ggaliens - 12-09-2012, 03:39 PM
RE: Shape Extruder? - optigon - 12-11-2012, 06:46 PM
Sure ... change hooks. - ggaliens - 12-11-2012, 06:56 PM
RE: Shape Extruder? - optigon - 12-11-2012, 07:35 PM
RE: Shape Extruder? - ggaliens - 12-11-2012, 10:13 PM
RE: Shape Extruder? - ggaliens - 12-18-2012, 05:52 PM
RE: Shape Extruder? - ggaliens - 12-18-2012, 08:09 PM
RE: Shape Extruder? - puzzledpaul - 12-19-2012, 09:06 AM
RE: Shape Extruder? - oort - 12-19-2012 03:30 PM
RE: Shape Extruder? - ggaliens - 12-19-2012, 04:17 PM
RE: Shape Extruder? - micheus - 12-19-2012, 05:32 PM
RE: Shape Extruder? - ggaliens - 12-19-2012, 05:48 PM
PP ... I did fix the Cube menu item problem. - ggaliens - 12-19-2012, 07:18 PM
|
User(s) browsing this thread: 1 Guest(s)