|
Measurements - Need some help
|
|
12-05-2012, 02:45 PM
(This post was last modified: 12-05-2012 02:46 PM by Fonte Boa.)
Post: #22
|
|||
|
|||
|
RE: Measurements - Need some help
Before Snap, if you create various cross sections they will measure 2.0;
after Snap, they measure a little less, but all them are equal! The new Snap operation you performed is nice!  As it moved those edges to their target, that changed the cross sections measures (but they are equal). No Intersect or Flatten problems here. At second video, if you use mmb Flatten instead rmb one, you will see that both cross sections will be coincident. __________________________________ http://www.youtube.com/wings3dchannel http://www.facebook.com/wings3dchannel |
|||
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)