Wings 3D Development Forum / Wings 3D / Interface & Usage v / Creating a hole in a cylinder off center

New Reply
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 
Share Thread:
Reddit Facebook Twitter
Creating a hole in a cylinder off center
10-28-2014, 02:48 PM
Post: #7
pashman Offline
Junior Member
 		Posts: 8
Joined: Oct 2014
RE: Creating a hole in a cylinder off center
Let me get the right version installed and then see if I can figure it out.
Tim
Find Reddit Facebook Twitter
Reply
New Reply


Messages In This Thread
RE: Creating a hole in a cylinder off center - pashman - 10-28-2014 02:48 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Wings 3D Home | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication