Creating a hole in a cylinder off center

New Reply

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Share Thread:

Threaded Mode | Linear Mode

Creating a hole in a cylinder off center

10-28-2014, 03:41 PM

Post: #9

pashman Offline

Junior Member

Posts: 8
Joined: Oct 2014

RE: Creating a hole in a cylinder off center

Folks, couldn't quite figure out how to get the plug-in installed, but installed the mlabs version of Wings3D that had the Boolean operators included. After a little bit of fiddling success is mine! See attached (rename .doc to .wings).

Attached File(s)
.doc

Test Model Shower Plate Copy.doc (Size: 10.95 KB / Downloads: 6)

Find

« Next Oldest | Next Newest »

New Reply

Messages In This Thread

Creating a hole in a cylinder off center - pashman - 10-27-2014, 11:23 PM

RE: Creating a hole in a cylinder off center - micheus - 10-27-2014, 11:34 PM

RE: Creating a hole in a cylinder off center - pashman - 10-28-2014, 12:39 AM

RE: Creating a hole in a cylinder off center - Radi - 10-28-2014, 02:03 AM

RE: Creating a hole in a cylinder off center - pashman - 10-28-2014, 10:32 AM

RE: Creating a hole in a cylinder off center - Radi - 10-28-2014, 02:09 PM

RE: Creating a hole in a cylinder off center - pashman - 10-28-2014, 02:48 PM

RE: Creating a hole in a cylinder off center - micheus - 10-28-2014, 03:26 PM

RE: Creating a hole in a cylinder off center - pashman - 10-28-2014 03:41 PM

RE: Creating a hole in a cylinder off center - micheus - 10-28-2014, 03:47 PM

RE: Creating a hole in a cylinder off center - ggaliens - 10-28-2014, 05:03 PM

RE: Creating a hole in a cylinder off center - pashman - 10-28-2014, 05:38 PM

RE: Creating a hole in a cylinder off center - micheus - 10-28-2014, 07:37 PM

RE: Creating a hole in a cylinder off center - Radi - 10-29-2014, 02:26 AM

RE: Creating a hole in a cylinder off center - micheus - 10-29-2014, 01:26 PM

RE: Creating a hole in a cylinder off center - marcusqueen - 11-03-2014, 06:43 PM

RE: Creating a hole in a cylinder off center - sandralambert - 11-27-2014, 03:34 PM

RE: Creating a hole in a cylinder off center - micheus - 11-27-2014, 04:24 PM

RE: Creating a hole in a cylinder off center - Radi - 11-27-2014, 05:02 PM

RE: Creating a hole in a cylinder off center - Geta-Ve - 12-12-2014, 09:15 AM

User(s) browsing this thread: 1 Guest(s)