Wings 3D Development Forum
/
Wings 3D
/
Interface & Usage 
/
Creating a hole in a cylinder off center
/
Creating a hole in a cylinder off center
|
Creating a hole in a cylinder off center
|
|
10-28-2014, 07:37 PM
(This post was last modified: 10-28-2014 08:17 PM by micheus.)
Post: #13
|
||||
|
||||
|
RE: Creating a hole in a cylinder off center
pashman, I took a look at you model and I think you need to review the hard edges in you model.
I also fixed the problem related to not attach .wings files. It should works fine now and by clicking on it you should be prompt about open it with Wings3d (in case you had assigned that file type during the install). 
|
||||
@MicheusVieira
MicheusVieira
Micheuss
micheus4wings3d|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)