Wings 3D Development Forum

Can I see your file for the above scenario ?

(01-03-2015, 03:53 PM)ggaliens Wrote: [ -> ]Can I see your file for the above scenario ?

Dump written 2015-1-3_17-15
Version: v1.5.3.2014-12-27---20-07.mlab
Window: "<Unknown Window Name>"
Reason: {badarg,[{erlang,port_control,
[esdl_port,5069,<<255,255,15,0>>],
[{file,"erlang.erl"},{line,2747}]},
{gl,pushAttrib,1,[{file,"gen/gl.erl"},{line,286}]},
{wings_pb,draw_position_1,1,
[{file,"wings_pb.erl"},{line,205}]},
{wings_pb,draw_position,1,[{file,"wings_pb.erl"},{line,200}]},
{wings_pb,loop,1,[{file,"wings_pb.erl"},{line,166}]}]}

Sorry ... I mean the .wings file to which the action was applied.

well, basically the object does not matter, since I used basics.

It still helps to know the context in which an operation is applied.

Could sure use some help testing the new function I added to Materials (outliner).

To Selection Groups
and
From Selection Groups

Greetings

wings-x64-1.5.3.2015-01-22---16-11.mlab

Material From selecion group has applied for me the selected material to an existing group, but only has worked once.
"to selection group" has created a group with the name on the input box, I think this dialog should be more understable (Please input the name of the group); the three options below are necessary?

Also if the group already exist there should be some feedback.

Thanks!

"Material From selection group"

What it is supposed to do for you is ... if your Material has been "emptied' maybe by AutoUV process of you applied some other material ... you can make it so that material is "reapplied" to faces in selection group with same name. It is as if "selection group" is a "back-up" for Materials.

"From Selection group" process does not make a new material for you.

---

"the three options below are necessary?"

Yes ... they are needed.

---

I have vast numbers of selection groups and materials and I like to shuffle them back and forth depending on my mood. So being able to match by partial is needed. Entering a complete name would not be so useful to me. But you can do it.

Still needing help in general bug finding across board in ManifoldLab.

Would be great to get a mix of different bugs from different parts of MLAB.

Mlab 1.5.3.2014.12-20--21-18

Well, this is not any particular bug but when I use 'Tubes from loop paths' and clean some field (for example 'ngon') "Error Parsing formula' appears. This is a little bit annoying. It's typical when you change the original value to required, so each time you get it... Could you turn it off?