+- Wings 3D Development Forum (https://www.wings3d.com/forum)
+-- Forum: Wings 3D (https://www.wings3d.com/forum/forumdisplay.php?fid=1)
+--- Forum: Gripes & Grumbles (https://www.wings3d.com/forum/forumdisplay.php?fid=4)
+--- Thread: Bevel command (/showthread.php?tid=3220)
Bevel command - ismacou - 06-08-2026
Hello dear administrators.
I would like to raise the following issue. Would it be possible for you to consider changing the behavior of the bevel command? I find it inconvenient that when executed on an edge loop, it modifies the hardness of the affected transverse edges at the beginning and end of the loop. The new transverse edges at the beginning and end always appear smooth, but the intermediate transverse edges of the loop remain unchanged. Do you think it would be beneficial (or even possible) to change this? Thank you in advance.
RE: Bevel command - micheus - 06-08-2026
I see. I already faced it.
I will see if I can do something about it.