(01-24-2017, 09:03 PM)micheus Wrote: Material render test in Kerkythea failed.
It doesn't matter what I change in the settings I never get control over the specularity as well as those black areas in the border doesn't disappear. I few like I need to add some thickness to it since it's a single edge .
The MLT also accuses that overlapped faces issue. It's very noticeable in the right leaf.
Hi Micheus
You can send material settings screenshot in Kerkythea?
Your model Monstera, has modeled the lower and the upper part?
This could be a problem.
It would be better, to have hole from bottom side of leaf.
Because I assume, you used the "clip mapping" to cut the not modeled parts.