02-10-2017, 02:58 PM
It is never a great idea to upgrade hardware to overcome what could be a software technical issue if for any reason the STL exporter should by itself ... be the source of poor performance.
You would really settle for a 50% improvement ?
If you can or would trust me to TEST EXPORT your models to see what I think about performance ... I'd at least try to see what's going on. But you might need to keep models confidential. You could always do a deform crumple before you send to me. LOL. It's topology that prob matters here ... not precise geometry.
There must be some way someone can do a sanity check for you before you spend $$$.
You would really settle for a 50% improvement ?
If you can or would trust me to TEST EXPORT your models to see what I think about performance ... I'd at least try to see what's going on. But you might need to keep models confidential. You could always do a deform crumple before you send to me. LOL. It's topology that prob matters here ... not precise geometry.
There must be some way someone can do a sanity check for you before you spend $$$.