04-03-2017, 03:22 PM
If I underestood you correctly you are looking for "L" button. After you select faces use "L" button. I hope thats it.
Wings 3D Development Forum
Wings 3D
Design & Development
Border select?
Border select?
|
|
| Messages In This Thread |
|
Border select? - by Dimitri - 04-03-2017, 02:17 PM
RE: Border select? - by micheus - 04-03-2017, 02:27 PM
RE: Border select? - by Marcin Maćkowiak - 04-03-2017, 03:22 PM
RE: Border select? - by micheus - 04-03-2017, 05:18 PM
RE: Border select? - by Dimitri - 04-04-2017, 06:17 AM
|