05-24-2017, 03:21 PM
Hi, welcome to forum.
Maybe your mesh isn't clean? Did you try to use cleanup? Perhaps you did unwanted edges and while extruding it's getting weird. You can always try to start everything again.
Start with cylinder, select one edge, use "G" to select edge ring, switch to faces and try to extrude. It should works fine without problems
Maybe your mesh isn't clean? Did you try to use cleanup? Perhaps you did unwanted edges and while extruding it's getting weird. You can always try to start everything again.
Start with cylinder, select one edge, use "G" to select edge ring, switch to faces and try to extrude. It should works fine without problems