06-22-2019, 11:13 AM
Couldn't find where to put this as it isn't a gripe, complaint or anything else I could see.
I use the absolute move command on a frequent basis and wondered if there was a way to "copy/paste" the position of a selected vertice/ face or edge.
At the moment, when I wish to use the absolute command I have to select the point I want, select move - absolute, and then copy the axis value I require to move something to.
It's a pain in the proverbial neck lol.
Just wondering
I use the absolute move command on a frequent basis and wondered if there was a way to "copy/paste" the position of a selected vertice/ face or edge.
At the moment, when I wish to use the absolute command I have to select the point I want, select move - absolute, and then copy the axis value I require to move something to.
It's a pain in the proverbial neck lol.
Just wondering