02-03-2021, 02:51 PM
Unchecking the box works ok. It still has a mind of its own, once I press the space bar. I think that is the problem.
Example: I select two edges and connect. The connection is still highlighted. To go to two other edges to cut them I have to deselect the still highlighted edge. I guess I could click to deselect, but suppose I subdivide a loop and hundreds of verts are lit. Naturally you would use the space bar to deselect and then we go back to the problem I mentioned. Do you have another workflow?
On the rwx exporter, the problem depends on the model and comes at inopportune moments. So I just avoid using it. I found a file I just created a month ago using2.2.6.1. It has a lot of custom textures, so I will simplify it before I make a copy available for troubleshooting.
Example: I select two edges and connect. The connection is still highlighted. To go to two other edges to cut them I have to deselect the still highlighted edge. I guess I could click to deselect, but suppose I subdivide a loop and hundreds of verts are lit. Naturally you would use the space bar to deselect and then we go back to the problem I mentioned. Do you have another workflow?
On the rwx exporter, the problem depends on the model and comes at inopportune moments. So I just avoid using it. I found a file I just created a month ago using2.2.6.1. It has a lot of custom textures, so I will simplify it before I make a copy available for troubleshooting.