03-09-2013, 06:18 PM
(This post was last modified: 03-09-2013, 06:19 PM by puzzledpaul.)
(03-09-2013, 01:27 PM)Dimitri Wrote: ... the 'connect' tool's workings has a dependency to the camera angle... and this make things very difficult to acquire accurate results by using it. Going back and forth to the camera-object align option too is very non practical and tiring...
D - as you might suspect, I'm aware that Tools | Connect view is linked to camera angle - this has both pros and cons (imo)
As I mentioned a long time ago - on several occasions - also with examples of feature extensions - imo, modifying and improving what already exists - and works - should've been given greater consideration, rather than just adding supposedly 'better' stuff.
As regards alignment of an object to create the initial 2 datum loops for this proposed new feature being more difficult using T| C ... compared with Plane Cut ... I'd suggest the jury's still out ... because I'd bet that Plane cut is often going to be used with view xyz ... in which case, there's be no difference
Whilst I can see the point (and underlying agenda) behind this feature - my main issue is one of integration with existing tools.
pp