12-20-2021, 07:56 AM
Here is what i see, on the number on top left you see that i have selected all faces.
https://ibb.co/P14JvFZ
There is no change with "Invert" function, still blank. The .obj files do work perfectly in every other 3d program, if its 3d craft, dead deer, meshmixer, blender...(but they all have an awful slow workprogress) just as it worked in Wings3d only 1 hour before... it did not work anymore.
Its ridiculous, Wings is the only program affected while it's the only one i am using.
Also there is everything fine with the exporting program, it must have something to do with my computer, so are there additional files Wings3d is needing? redistribution C+++... DirectX?
For example one time, one of these framework files suddenly didn't work properly and because of that one program wasn't running anymore, so i reinstalled the framework pack and it was working again.
https://ibb.co/P14JvFZ
There is no change with "Invert" function, still blank. The .obj files do work perfectly in every other 3d program, if its 3d craft, dead deer, meshmixer, blender...(but they all have an awful slow workprogress) just as it worked in Wings3d only 1 hour before... it did not work anymore.
Its ridiculous, Wings is the only program affected while it's the only one i am using.
Also there is everything fine with the exporting program, it must have something to do with my computer, so are there additional files Wings3d is needing? redistribution C+++... DirectX?
For example one time, one of these framework files suddenly didn't work properly and because of that one program wasn't running anymore, so i reinstalled the framework pack and it was working again.