L-shaped roof overhang - is there a better way?

[tkbd]

Hi!mbbmbbmm
Thanks for share the information.
IMHO Wings3D modeling flow is similar woodcrafting processing in the real world.
It's convenient to make a jig (temporary object)for virtualy set and control a vector or position.
So,I think the method using intersect command and a temorary plane is a good idea!! Cheer!

The workflow is not so terrible and the end result is good. But it is just a little tedious to repeat. Is there a better, faster way to achieve it?

The way I tried it also takes time(it is many commands and steps too).
The current Boolean doesn't support coplaner, so we will manually combine it...

1. Switch Face mode:To Make a jig to select the roof(diagonal by half) and shell extrude to Y up axis
2. Switch Face mode: Apply shell extrude overhang from inside corner of L shape roof.
3. Switch Body mode: Combine two overhanged objects (These were shell extruded in STEP 2)
4. Swith Body mode: Select overhang object and apply Plane cut by MMB(it loop cut)
4-1.(Plane cut) Secondary selection ---- Select a side face of the jig object.
5. Switch Body mode : Select the roof and overhang ,apply weld command to them.