04-08-2013, 02:32 AM
Dimitri ... remind me to make you a video of new tubes from selection.
1) Pick hard-edge Junctions after BOOLEAN.
2) Interrupt JUNCTIONS with a vertex bevel. This requires a new selector to find the junction vertices, I think. (So I wrote one to release later).
3) Make tubes along all the boolean intersect lines in one pass.
I got this workflow going. It seems fun and like something you might enjoy.
1) Pick hard-edge Junctions after BOOLEAN.
2) Interrupt JUNCTIONS with a vertex bevel. This requires a new selector to find the junction vertices, I think. (So I wrote one to release later).
3) Make tubes along all the boolean intersect lines in one pass.
I got this workflow going. It seems fun and like something you might enjoy.