11-24-2012, 10:22 PM
There hasn't been a new build available for a year now. It might be fixed in the source but not in any releases.
I can tell you that the model you linked to has some geometry problems, but I think you already know that.
It may help if you select the whole model, then Face > Hole RMB; that will close all the holes. After that, Separate and Weld and see if it goes better.
I can tell you that the model you linked to has some geometry problems, but I think you already know that.
It may help if you select the whole model, then Face > Hole RMB; that will close all the holes. After that, Separate and Weld and see if it goes better.