10-24-2013, 12:09 PM
Hi,
Wings3D is important part of my 3D pipeline so I'd like to integrate it with my system. I'd like to install Wings3D on my Funtoo/Gentoo based system, but I'm facing problem connected with compatibility. My setup is:
erlang-15.2.3.1
libsdl-1.2.14-r6
esdl-1.0.1
Wings3D-1.4.1 sources
When I run Wings compiled by Erlang R15B03 I get:
http://bpaste.net/show/RdwJa1L2sJcNN4jissAI/
AFAIK Wings3D should be compiled using Erlang R14, but unfortunately this release of Erlang isn't in Gentoo portage tree. Available versions are: R15 and R16, but compiling with R16 fails because parameterized modules are not supported anymore.
I'd like to ask is there any way to successfully compile and run Wings3D using Erlang R15 or R16.
Michał
Wings3D is important part of my 3D pipeline so I'd like to integrate it with my system. I'd like to install Wings3D on my Funtoo/Gentoo based system, but I'm facing problem connected with compatibility. My setup is:
erlang-15.2.3.1
libsdl-1.2.14-r6
esdl-1.0.1
Wings3D-1.4.1 sources
When I run Wings compiled by Erlang R15B03 I get:
http://bpaste.net/show/RdwJa1L2sJcNN4jissAI/
AFAIK Wings3D should be compiled using Erlang R14, but unfortunately this release of Erlang isn't in Gentoo portage tree. Available versions are: R15 and R16, but compiling with R16 fails because parameterized modules are not supported anymore.
I'd like to ask is there any way to successfully compile and run Wings3D using Erlang R15 or R16.
Michał