Sorry, i didnt read your initial question with attention...
<<So with the cube side on, is there a technique to marquee select the end of the cube and select that face that is on that side?, instead of having to keep rotating the cube to select that face then go back to the side or top view to extrude to the image.
Hope that made sense>>
(1) You can go to Window|New Geometry and position the new viewport in a confortable angle to select back cube face in a single click, without have rotate around the cube to do this
(2) Alternative way to select that back face cube in a single click without rotate viewport is to use Window|Selection Groups (plugin provided by Micheus), It allows you to use directly (single clicks) the top menu Select|Selection Groups commands: very useful for you and everybody.
These are the two approachs i would use.
Coud you try them?
<< Is it possible to assign hot keys to Extrude, Scale and move?>>
Too any individual command and almost all their variants: you will Wings is great. Today, Wings doesnt allow to hotkey an entire sequence.
<<I followed the instructions but after hitting the Ins key or the / key nothing happened.>>
If you hit INS, the info line at botton of Wings area have to inform you the next(s) steps to perform. Did you really follow all the info line instructions after you point to the command you want to shortcut and hit INS?
(i have to record a video about this...)
EDIT:
again but in a fresh forum we were typing together, Paul? :/
<<So with the cube side on, is there a technique to marquee select the end of the cube and select that face that is on that side?, instead of having to keep rotating the cube to select that face then go back to the side or top view to extrude to the image.
Hope that made sense>>
(1) You can go to Window|New Geometry and position the new viewport in a confortable angle to select back cube face in a single click, without have rotate around the cube to do this
(2) Alternative way to select that back face cube in a single click without rotate viewport is to use Window|Selection Groups (plugin provided by Micheus), It allows you to use directly (single clicks) the top menu Select|Selection Groups commands: very useful for you and everybody.
These are the two approachs i would use.
Coud you try them?
<< Is it possible to assign hot keys to Extrude, Scale and move?>>
Too any individual command and almost all their variants: you will Wings is great.
Today, Wings doesnt allow to hotkey an entire sequence.<<I followed the instructions but after hitting the Ins key or the / key nothing happened.>>
If you hit INS, the info line at botton of Wings area have to inform you the next(s) steps to perform. Did you really follow all the info line instructions after you point to the command you want to shortcut and hit INS?
(i have to record a video about this...)
EDIT:
again but in a fresh forum we were typing together, Paul? :/
__________________________________
www.youtube.com/wings3dchannel
http://www.facebook.com/wings3dchannel
www.youtube.com/wings3dchannel
http://www.facebook.com/wings3dchannel