12-30-2013, 06:02 PM
(This post was last modified: 12-30-2013, 06:03 PM by VisualMelon.)
Howdy,
If you select (or aim at) a vertex and then (With the mouse) RMB|Weld it then the selected vertex is indicated clearly. However, if you just aim at it, and RMB|Weld via the Keyboard (bound to W on my setup), then it isn't indicated. If you select a vertex and use the Keyboard to RMB|Weld, it works just like with the mouse.
Tiny little niggle, but when I'm welding together models and accidentally hit W I end up getting very confused, because I can select the vertex I want to weld, but of course W doesn't then work again, and the discrete interface changes don't shout at me that I'm in the wrong mode.
Is this intentional or should it be indicated when using the keyboard? Seems like it's just a slight inconsistency.
If you select (or aim at) a vertex and then (With the mouse) RMB|Weld it then the selected vertex is indicated clearly. However, if you just aim at it, and RMB|Weld via the Keyboard (bound to W on my setup), then it isn't indicated. If you select a vertex and use the Keyboard to RMB|Weld, it works just like with the mouse.
Tiny little niggle, but when I'm welding together models and accidentally hit W I end up getting very confused, because I can select the vertex I want to weld, but of course W doesn't then work again, and the discrete interface changes don't shout at me that I'm in the wrong mode.
Is this intentional or should it be indicated when using the keyboard? Seems like it's just a slight inconsistency.